CIC FireFly Testbed

Installing Setup on WRT160NL router

These instructions are for configuring the router in wireless client mode on an infrastructure network. In this case, the configure files are for CMU's wireless network, but changing that should be relatively simple. In order to load the full firmware image you need to first load a small backfire image and then a second larger one.

  • Configure IP manually (Gateway: 192.168.1.1)
  • Flash with standard OpenWRT image backfire.bin using the default Linksys web upgrade
  • Goto Backup/flash menu
    • Disable keep settings
  • Flash with [[ff_image.bin| raw ff_image.bin] using the openwrt web upgrade
    • Wait for reboot
  • Set password
  • Goto network->wifi
    • Click on "scan button"
    • Join CMU
    • submit, save and apply
  • Goto Luci interface page
  • scp etc-ff-image.tar :/tmp/
  • ssh
    • Check if etc-ff-image.tar is in tmp
  • Replace etc directory
    • rm –rf /etc/
    • Tar xvf /tmp/etc-ff-image.tar
    • MAC address in Luci should updated and change
    • Copy MAC from interfaces window
  • Updated MAC address in /etc/config/wireless
    • edit /etc/config/wireless
    • Change macaddr to copied MAC and save
  • Reboot

sag-placement.png - sag layout (20.8 kB) Anthony Rowe, 02/13/2008 05:29 pm

cic_testbed.png - CIC Testbed node placement (339 kB) Anthony Rowe, 03/17/2008 02:29 pm

backfire.bin - Stock OpenWRT backfire image (3.1 MB) Anthony Rowe, 01/25/2012 09:35 pm

ff_image.bin (4.6 MB) Anthony Rowe, 01/25/2012 09:36 pm

ff_etc.tar (674 kB) Anthony Rowe, 01/25/2012 09:47 pm